Assembled Parts
Hub
3 Tubes
Quilt
3
Quilt
• Wash the quilt in cold water on the gentle cycle. Do not use bleach. Tumble dry low.
Tubes, Hub and Toys
• Wipe the surface with a clean cloth dampened with a mild soap and water solution. Do not
use bleach.
• Do not immerse the monkey toy.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
P5333pr-0920
PRINTED IN CHINA
4
Setup
Tab
Hub
Tube
Tube
1
• Insert and snap the tubes into the hub.
2
Quilt
Large Loop
• Lay the quilt out on a flat surface with the
decorated side up.
• Fit the end of each tube through the large loops
on the quilt. Make sure the loop is fitted below
the tab on each tube.
5
• Hang the toys from any of the loops around the gym.
• Spin the roller on the monkey for musical tunes and fun sounds.
6
Storage
Hub
Tube
3
• Roll the quilt, as shown.
1
Loop
Storage
Strap
• Push the button on top of the hub and remove
each tube.
4
• Slide one storage strap through the loop.
• Tie the storage straps to hold the quilt in place.
Large Carry Loop
2
• Place the tubes, hub and toys near the top of
the quilt.
7
Battery Replacement
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
1.5V x 3
LR44 or Equivalent
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Locate the battery compartment on the back of
the toy.
• Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door, and throw exhausted
batteries away.
• Insert three, new, button cell (LR44) alkaline
batteries, as indicated inside the
battery compartment.
• Replace the battery compartment door and
tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• If this toy begins to operate erratically, you may
need to reset the electronics. Remove the batteries
and replace them back in the toy.
• When sounds from this toy become faint or stop,
it is time for an adult to change the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
8
|
Ei Electronics Smoke Alarm Ei428 User Manual
Essick Air Humidifier H10 400 User Manual
Eton Clock Radio SOUND101 User Manual
Fiesta Gas Grill EZT34535 B303 User Manual
Fisher Weather Radio 244EH User Manual
Fujitsu Two Way Radio MB2147 583 User Manual
Gefen Marine Battery EXT IP 2 RS2322 User Manual
GE Mixer 169160 User Manual
GenTran Portable Generator 6370C User Manual
Giant Automobile Parts GP5136 5100 User Manual