Eiki Projector AH 55201 User Manual

1
Press STANDBY-ON on the projector or on the remote control to  
put the projector into standby mode.  
Disconnect the power cord and unplug the power cord from the AC  
socket after the cooling fan stops.  
Do not attempt to exchange the lens  
when the projector is installed  
hanging from the ceiling. Injury may  
occur if the lens cover and lens fall.  
Installation Manual  
AH-55201  
AH-55301  
AH-55401  
AH-55501  
AH-55601  
AH-55701  
AH-55801  
STANDBY-ON button  
Before exchanging the lens, reset  
lens shift to the center position. (The  
lens shift is located at the center in  
the factory preset.)  
H&V LENS SHIFT  
button  
When resetting the lens shift to the  
center position, press H&V LENS  
SHIFT and then press UNDO.  
The lens shift reset screen will be  
displayed. Select “Yes” to reset.  
UNDO button  
Power cord  
2
3
Remove the lens cover.  
Press the lens cover removal button (1). Slide the lens cover forward  
(2).  
Turn the lens in the direction of the arrow while pressing the lens  
removal lever to pull the lens out.  
Removal lever  
2
1
 

EAW Speaker SB185C User Manual
Eiki CRT Television LC X4A User Manual
Electro Voice Speaker Sb120 User Manual
Fagor America Electric Pressure Cooker M16301272 User Manual
Foster Refrigerator FHG 2L User Manual
Fostex Recording Equipment X 14 User Manual
Frigidaire Washer FWSC235RF User Manual
Fujitsu Video Game Keyboard KVM S3 User Manual
Furuno SONAR CH300 User Manual
Gateway Modem SMCD3GN User Manual