Fisher Paykel Dryer Accessories 94832 User Manual

Dryer Plinth Kit (115mm & Under Counter)

Part Numbers: 94832 & 94852

KIT COMPONENTS

Wrapper plinth 115mm / Under counter

Back plinth 115mm / Under counter

Screw (15)

Fit plinth between

wrapper & base panel

Beam (2)

Foot (4)

Instruction leaflet

Back Panel

ASSEMBLY METHOD

1. Lay dryer on its back.

2. Loosen all 16 screws around perimeter of dryer base. Do not remove

wheels or feet.

3. Fit plinth by inserting the top flange of plinth (the flange with the 16

notches) between the base panel and dryer cabinet bottom flange.

Fit front flange first springing the sides outward to assist assembly.

Plinth

4. Adjust plinth to fit flush with the cabinet then tighten screws.

5. Fit front and rear beams using the screws provided.

Screws

6. Remove screws from lower rear panel and re-use to fit back plinth

panel. Also use screws supplied to secure sides and bottom edge of

panel.

7. Screw feet into beams.

Beams

Foot

8. Stand dryer upright and adjust feet to desired height.

Introduction Date: September 2004

Instruction Sheet Pt No. 460633 Issue E